Results 1 to 5 of 5
  1. #1

    Join Date
    May 2009
    Location
    Broadstairs, Kent, England
    Posts
    138
    +1
    2

    2000 XP steps to remove engine?

    Can someone post the steps to remove an XP engine please? Thanks


  2. #2
    AndinoWatercraft's Avatar
    Join Date
    Feb 2008
    Location
    Puerto Rico
    Posts
    306
    +1
    4
    At least this is how I would do it.

    1: Disconect the battery

    2: Shut the fuel valve and loose or remove carbs.

    3: Disconect the starter cable.

    4: Remove the tune pipe and water hoses atached to it. I manage to take it in one piece

    5: Disconect the oil lines and the oil pump cable. also disconect the water lines (cyl head and from rear cranckase)

    6: Disconect the stator connector and the mpem ground in the stator cover.

    7: Loose the engine mounts.

    8: Loose the rubber boot on the PTO

    Then is off to go.


    You should have it off in less than an our. If is the first time.

  3. #3

    Join Date
    May 2009
    Location
    Broadstairs, Kent, England
    Posts
    138
    +1
    2
    Thanks. Does anything need to done with the driveshaft (eg does it need to be pulled out first via the jet pump?)

  4. #4
    Joe Stang's Avatar
    Join Date
    Aug 2008
    Location
    Durham, CT
    Posts
    1,928
    +1
    61
    No because it's a coupler setup you angle the front of the engine up and it will cOme right out.

    You can remove the engine with the pipe still connected but being your first time I would remove it for your benefit.

  5. #5

    Join Date
    May 2009
    Location
    Broadstairs, Kent, England
    Posts
    138
    +1
    2
    I guess it must be easier than removing my RXP engine!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to remove a broken engine mount bolt? Virage TXi FRC hull
    By K447 in forum Polaris Open Discussion
    Replies: 20
    Last Post: 07-21-2016, 07:24 PM
  2. Step by step to remove cylinder head?
    By krouchchocolate in forum 4-Tec Performance
    Replies: 11
    Last Post: 06-03-2011, 04:08 PM
  3. Do I need to remove the engine to inpect hull?
    By Dazza169 in forum Yamaha Open Discussion
    Replies: 1
    Last Post: 01-18-2009, 10:35 AM
  4. Where is the thread w/steps to remove 4tec engine?
    By JeffSki in forum 4-Tec Performance
    Replies: 6
    Last Post: 06-04-2008, 06:15 PM
  5. How-To: Removing the engine cowling.
    By MikeTrin in forum Sea Doo How To & FAQs
    Replies: 8
    Last Post: 06-23-2005, 10:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •