Thread: 750sx water line routing.
04-12-2012, 04:36 PM #1
750sx water line routing.
Need some help. I'm lost with the water lines on this ski. The last owner added a few dumps. How is the factory water line routed?
Is it from the feed to the manifold up thru the head and out the pipe? I have one more nipple under the exhaust manifold its a 3/8".
The only thing I can think of is a flush kit that went on that nipple or he used the wrong fitting on the manifold Thanks in advance.
04-12-2012, 09:06 PM #2
The line from the pump goes into the manifold near the starter. There is another U-shaped hose from the top of the exhaust to the cylinder head. This has a T fitting that is capped. That's the flush port. There is also a little hose that goes to the overheat sensor, then out the peehole.
04-13-2012, 09:54 AM #3
Thanks once again Steve. I may have missed the temp sensor but I don't recall seeing one. The fiting that should be capped is on the exhaust manifold instead of the head. On this ski the feed from the pump is a 1/2" . Not sure if thats a factory set up. I give it a shot and see if it overheats. Thnaks
04-14-2012, 09:29 AM #4
I don't know about the SX, but on the other 750s, the temp sensor is mounted remotely in the pisser line.
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
By jdlrocu in forum 4-Tec PerformanceReplies: 10Last Post: 07-14-2011, 12:11 AM
By Tazz in forum Sea Doo Open DiscussionReplies: 0Last Post: 08-03-2010, 09:54 AM
By SJ-(KY) in forum Kawasaki PWC Performance (2-stroke)Replies: 4Last Post: 07-12-2010, 11:14 AM
By RXP'in in MI in forum 4-Tec PerformanceReplies: 6Last Post: 01-11-2009, 09:36 PM
By RXP'in in MI in forum 4-Tec PerformanceReplies: 2Last Post: 01-08-2008, 11:58 AM