Results 1 to 4 of 4
  1. #1

    Question Need some suggestions please!!!!!

    I am looking to have my engine in my 2001 kawasaki ultra 150 rebuilt!there are two places i found to do it but i want to make sure it will be done right and also that they will use quality oem parts,but...im really not sure one of the places is JETSKIPARTS.BIZOUT OF CALIFORNIA OR PWC OUT OF NEW YORK I am open for any suggestions!!please help!!!


  2. #2
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,014
    +1
    285
    Welcome aboard, cgore8!

    It's blasphemous to refer to an Ultra 150 as a Waverunner, but we'll let you slide this time.

    Is there something wrong with your engine, or is it just time to do a top?

    Carl, at Island Racing in Long Island, NY does really good work--but I don't know if he works on the Ultra engines or not. He deals primarily with Yamahas.

    You can email him at: [email protected]

  3. #3
    i had it out last year and it took on some salt water, sat up for like three weeks the engine was not turning over i finally got it started and its not running the same ever since it wont even do over 30 mph now!i just feel like it would be to my best interest to have it rebuilt !

  4. #4
    steve45's Avatar
    Join Date
    Feb 2008
    Location
    Texas
    Posts
    5,014
    +1
    285
    Did water get inside the engine? If so, expect a very large bill. You may need a crank & rods, starter, starter drive, balance shaft & gears, carbs, etc. If water got into the electrical boxes, they're probably toast, too. In salt water, it takes less than a day for rust to form.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. need some advice please guys
    By Hydrotherapy in forum Yamaha PWC Performance (2-stroke)
    Replies: 22
    Last Post: 05-16-2007, 08:39 PM
  2. i need some advice please?
    By Mr Dee's in forum Sea Doo Open Discussion
    Replies: 13
    Last Post: 03-25-2007, 09:45 PM
  3. Changing out bearings: need some help please
    By SeaDoocer in forum 4-Tec Performance
    Replies: 8
    Last Post: 11-06-2006, 12:51 AM
  4. Jerry I need some advice please
    By SeaDoocer in forum 4-Tec Performance
    Replies: 4
    Last Post: 09-10-2006, 11:23 PM
  5. Riva Power Filter extension,I need some suggestions and help
    By rxp_boy in forum 4-Tec Performance
    Replies: 1
    Last Post: 11-13-2005, 06:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •