Results 1 to 4 of 4
  1. #1

    Just replaced my plastic steering nuts...easy

    I already have the pump removed to replace my wear ring following these instructions...

    http://www.greenhulk.net/forums/show...p?t=536&page=3


    then simply slipped off the rubber grommets, unscrewed the plastic nuts, unscrewed the end pieces, slipped them off the cables and slipped on the new aluminum ones. Screwed them back in snugly, slid the rubber grommets back into position over the cable...done.


  2. #2
    NastyStang's Avatar
    Join Date
    Jun 2009
    Location
    Central Florida
    Posts
    156
    +1
    3
    Do you need any special tools to remove the pump? I know you need the impeller tool to do the wear ring.

  3. #3
    No special tools needed, took maybe 15 minutes tops, I did find the shop which previously replaced the wear had stripped out an Allen head bolt and left off one of the washers...I swear, on any repair or maintenance I'm doing it all myself if even remotely possible.

  4. #4
    The pictures made it super easy.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Easiest way to replace those plastic steering and reverse nuts.
    By faslodex in forum Sea Doo Open Discussion
    Replies: 20
    Last Post: 07-26-2017, 12:07 AM
  2. plastic steering nut
    By jk111 in forum Sea Doo Open Discussion
    Replies: 2
    Last Post: 02-10-2014, 01:17 AM
  3. WTB I need a aluminum jet pump for my 2003 GTX to replace my plastic one.
    By hotbird in forum Sea Doo Classifieds
    Replies: 0
    Last Post: 05-25-2012, 08:16 PM
  4. Replies: 7
    Last Post: 08-12-2009, 01:18 PM
  5. Replies: 3
    Last Post: 08-05-2008, 04:07 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •