Results 1 to 2 of 2
  1. #1

    Question gp1200 aftermarket handle bars..

    heya guys, hope ur all well...

    im bout to buy some aftermarket handle bars for my 99 gp1200.. probably pro taper or the like, but basicly i was wondering what brand and most importantly WHAT BEND every one uses? its doing my head in trying to figure out which ones to get!!

    alot of them now are "fat bars" and are 28mm at the mounting point and taper to 22 mm at the ends. iv taken all the mesurments of the factory bars and they are obvoiusly 22mm ( or 7/8. sorry im from australia ) does any one know if the pro taper conversion clamps fit on the gp's?

    not a big deal as ill just get a set of 22mm ones if needed.. just realy want to know what bend to get if possible..

    any help/ideas/info would be great

    thanks in advance, mark.


  2. #2
    im lookin at these at the moment.. as the "seem" like they may be ok? http://www.ebay.com.au/itm/330669658...84.m1423.l2649

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. aftermarket handle bars on stock steerin system
    By jbuhles in forum 2-Stroke Performance
    Replies: 9
    Last Post: 04-16-2011, 10:43 PM
  2. what is the benefit of aftermarket handle bars?
    By noshowallgo in forum Yamaha PWC Performance (2-stroke)
    Replies: 12
    Last Post: 09-18-2008, 12:41 AM
  3. Finger throttle and aftermarket Handle bars (96 xp)
    By 240witSR in forum 2-Stroke Performance
    Replies: 8
    Last Post: 05-15-2008, 03:12 PM
  4. Covers for Aftermarket Handle Bars
    By Chrisrokc in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 10-09-2007, 09:08 PM
  5. Aftermarket Handle Bars
    By Chrisrokc in forum Yamaha PWC Performance (2-stroke)
    Replies: 11
    Last Post: 03-07-2007, 04:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •