Results 1 to 5 of 5
  1. #1

    Join Date
    May 2009
    Location
    Nashville, Tn
    Posts
    788
    +1
    90

    Cooling Line Pressure Relief

    What are you guys using for cooling line pressure relief? I'm going to be installing the fizzle IC next week and have a dedicated line running from the pump to the IC. Was considering putting one in to relieve water pressure off of the IC at higher speeds. Thanks.


  2. #2
    Why? Just asking

  3. #3

    Join Date
    May 2009
    Location
    Nashville, Tn
    Posts
    788
    +1
    90
    Just to limit pressure on the core at higher speeds

  4. #4
    I would think its made to handle that pressure???????

  5. #5
    Kelly_A's Avatar
    Join Date
    Dec 2009
    Location
    Central Oklahoma
    Posts
    660
    +1
    17
    So far as I know, no one is running a relief w/ their dedicated line. So long as the IC outlet pressure is equal or greater than inlet pressure, you'll be fine. If you mix and match stock and aftermarket hoses, make sure the ID of the outlet line is as large or larger than that inlet line ID. If you go with the existing stock side pisser and are concerned about restriction, you can tee off the outlet and install another pisser on the side or in the rear. You can also drill out the stock pisser slightly to reduce restriction.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Is it better to relief cooling water pressure?
    By chris1200 in forum Yamaha PWC Performance (2-stroke)
    Replies: 10
    Last Post: 04-01-2012, 08:19 AM
  2. Water/ cooling lines
    By brandn in forum Yamaha PWC Performance (2-stroke)
    Replies: 4
    Last Post: 04-18-2010, 10:01 AM
  3. Nervous about the antifreeze in my cooling lines.
    By xplayer2885 in forum Polaris Open Discussion
    Replies: 6
    Last Post: 01-19-2007, 01:19 AM
  4. cooling lines on the old 99model GP's
    By ozzygp in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 07-18-2006, 07:06 AM
  5. Torque setting for oil pressure relief valve plug???
    By CRS in forum 4-Tec Performance
    Replies: 4
    Last Post: 08-27-2005, 10:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •