Results 1 to 5 of 5

Thread: Xlt 1200 2002

  1. #1
    2011VXR's Avatar
    Join Date
    Oct 2011
    Location
    Miami Fla
    Posts
    203

    Xlt 1200 2002

    Need help i have a xlt 1200 need to know what jet's to put in, the one's in there are 87.5 low 117.5 high it has a d plate with chip no port job. and it's about 10lb on psi on the valve relef.


  2. #2
    2011VXR's Avatar
    Join Date
    Oct 2011
    Location
    Miami Fla
    Posts
    203
    help please.

  3. #3
    2011VXR's Avatar
    Join Date
    Oct 2011
    Location
    Miami Fla
    Posts
    203
    i

  4. #4

    Join Date
    Aug 2006
    Location
    Indiana
    Posts
    1,274
    +1
    81
    These ski's run a bit lean on low jets, I usually put 92.5 or 95 in if you are not changing up to flame arrestors. 95 is what the stock GPR uses for the same motor. What is the 10" valve relief you are talking of? The pop-off on these carbs is like 65psi stock.

  5. #5
    2011VXR's Avatar
    Join Date
    Oct 2011
    Location
    Miami Fla
    Posts
    203
    thanks will check

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. xlt 1200 2002 possible power valve dropped ?
    By dogturd21 in forum Yamaha Open Discussion
    Replies: 0
    Last Post: 08-23-2014, 11:21 PM
  2. Xlt 1200 2002
    By jeivegv in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 05-20-2013, 01:54 PM
  3. 2002 Yamaha XLT 1200 Blown Motor Pics- Cause?
    By nightrider05 in forum Yamaha PWC Performance (2-stroke)
    Replies: 27
    Last Post: 10-27-2010, 11:24 PM
  4. Parting out 2002 Yamaha XLT 1200-St.Louis Missouri
    By nightrider05 in forum Yamaha Classifieds
    Replies: 36
    Last Post: 08-11-2009, 07:49 PM
  5. HELP! 2002 Yamaha XLT 1200
    By crudo in forum Yamaha PWC Performance (2-stroke)
    Replies: 13
    Last Post: 07-26-2008, 11:56 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •