05-18-2012, 10:52 AM #1
re installing my rxpx motor,added a bunch of stuff any hints,tips,etc ?
re installing my motor in my 09 rxpx, along with rebuilt et 137 , mtx-l, groco strainer, catch can, 4" kani flex, rule 750 auto, FF pipe, entire pump setup going back now that its repitched, cleaned the IC the way Jerry showed in his sticky as well.
so i got the motor back in, drive shaft, new carbon ring and support, bellows all together, as well as FF pipe in.
gotta install my strainer, bilge pump, catch can, IC, Wideband, super charger, wire stuff up and re install rest of ski components.
Any tips,tricks and or advice on where to start so im not back tracking?
where is a good spot to install the bilge pump, and best way to keep it in place?
will edit this as i remember stuff i had questions bout
05-18-2012, 05:09 PM #2
can some one tell me the placement of the exhaust hose? does it go behind the Inter cooler? pic maybe
05-18-2012, 10:14 PM #3
I mounted my bilge pump next to the pump tunnel on the waterbox side.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)