Results 1 to 2 of 2
  1. #1

    best way to remove 1992 gtx 580 carbs

    I have a 1992 gtx 587, I was going to clean the carbs, but I can't get a wrench on the carb nuts, or the four manifold bolts, that leaves either removing the rotory valve cover or remove the engine?


  2. #2
    I pulled the cover when I did mine. I do not see any other way to do it. I made sure I was careful and pulled the cover out a bit and kept the valve on the shaft. Not as bad as it looks.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 2000 GTX suggestions on best way to remove airbox
    By Jaym24 in forum 2-Stroke Performance
    Replies: 4
    Last Post: 07-31-2013, 10:34 PM
  2. Whats the best way to remove the carbs from a polari 650slt?
    By tberg47 in forum Polaris How To & FAQs
    Replies: 10
    Last Post: 06-27-2013, 11:17 AM
  3. best way to remove factory stickers
    By txgp1300r in forum Yamaha PWC Performance (2-stroke)
    Replies: 18
    Last Post: 07-07-2007, 04:03 PM
  4. Best way to remove pump shoe ?
    By slow1300 in forum Yamaha PWC Performance (2-stroke)
    Replies: 10
    Last Post: 02-21-2007, 09:32 PM
  5. Best way to remove JB Weld, epoxy
    By Kinchyle in forum Sea Doo Open Discussion
    Replies: 3
    Last Post: 04-04-2006, 04:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •