05-21-2012, 10:03 PM #1
2 Big Boxes Of Parts Just Arrived At My Door
I can't wait to start installing :
Riva 2 Degree Pump Wedge
Riva VTS Extension Rod
Riva 159mm Stainless Steel Wear Ring
Solas 15/20R Impeller
Riva/Jettrim Seat Cover
Riva Pro-Series Sponson Kit
Riva Billet Finger Thottle and Adapter
Riva Pro-Series O.P.A.S Kit
Riva Thru Hull Rear Exhaust Kit
Riva 32" Bars
ODI Ruffian Lock On Grips
UMI Billet Aluminum VTS Switch Housing
Any suggestions on other mods while installing this stuff?
(Already installed Riva Power Filter Kit, Riva Top-Loader Intake Grate, Forge Dual Chamber Billet Aluminum Blow Off Valve, Auto Meter Boost Gauge)
05-21-2012, 10:30 PM #2
should've got a 4 inch intake, Blow off valves are not necessary in our application. 14/19r would have been a better prop for your setup. 15/20r is going to be too steep if your not upping the boost or adding an external intercooler. Hope you didn't buy the riva finger throttle and handle bar extension kit with riva bars. You've got your work cut out for you all at one time. I'm assuming this is for an rxp.
05-21-2012, 10:45 PM #3
- Join Date
- May 2011
- West Texas
I vote external intercooler, x charger, 42's.
That will make the seat of your pants happy... for now.
05-22-2012, 07:49 AM #4
05-22-2012, 07:56 AM #5
What s/c impeller are you going to go with
05-22-2012, 07:59 AM #6
05-22-2012, 08:00 AM #7
05-22-2012, 10:15 AM #8
et127 if your wanting to stay with a stock 215 housing or swap it out with a x charger. you'll need 42 pound injectors and with an ext ic you'll need a rising rate fuel regulator. and a air to fuel monitoring device.
05-22-2012, 01:03 PM #9
i run the et 127 and its such a great wheel if your staying with the stock scer.... amazing amazing hands down wheel... very very snappy.
05-22-2012, 01:30 PM #10
They're also hard to find
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)