05-27-2012, 01:33 PM #1
2009 rxpx 2006 rxp New trailor for sale
2 skis and trailor the rxpx has 36 hours on it basic mods air grate runs 73mph 75 low on gas,New 2011 SHORELANDER trailor 2006 rxp 84-85 mph the best of the best put into this ski.Both these skis are in great shape.Here is the list of what the 2006 rxp has with pics and vids of it...I am asking 17,000 for the whole deal..
Ok Tom here is the list of parts for the build of your 06 RXP, pretty sure I covered everything
Motor and internals:
Complete motor rebuild using all new oem internal parts
Bore and hone block for new .010 pistons
Replaced crankshaft and balanced the rotating assembly (crank,rods,pistons,flywheel)
Riva .010 piston kit (balanced)
Carrillo rod set (balanced)
Rotax Racing lightweight flywheel
Rotax Racing lightweight cam gear
lightened stock balance shaft
lightened stock 051 camshaft
New pto cover with 08' oiling modification
Race ported head
ferrera stainless valves
3 angle valve job
New valve seals
Riva valve train kit
ARP head stud kit
ARP case stud kit
ARP rocker arm kit
ARP flywheel bolt kit
New magneto stator
New flywheel magneto
New pto bearing assy.
3 Rude supercharger with Rotax Racing clutch washers,viton seal and Mcmaster carr washers installed
Aeromotive rising rate fuel pressure regulator with gauge
Braided high pressure fuel lines and fittings
Tank adaptor for rrfpr
Rotax Racing 8800 rpm ECU
07 wiring harness to run 8800 rpm ecu
07 dess harness
Rude fuel controller
66 lbs fuel injectors
Walbro 255 ltr fuel pump
Fuel pump relay
Riva Rear air adaptor with hose and clamps
Riva open loop cooling kit
Riva open loop ride plate
AFR bung installed in J-pipe
Digital AFR gauge
Digital boost gauge
Digital temp guage
Guage pod for glove box
New battery from Riva
THIS SKI has 10 easy break in hours and 12 hours of ride time.
turn up your speakers for vids....Pm me if interested.....
Last edited by icerat4; 06-04-2012 at 08:17 AM.
05-28-2012, 01:36 PM #2
Tom sent me message and said he is ready to move these skis with a solid offer.
All work done on skis was done by a top notch/meticulous builder who has done motors for me also so I know there will be no disappointment.
Sent from my ADR6400L using Tapatalk
05-28-2012, 05:18 PM #3
05-31-2012, 08:02 AM #4
I do have all 3 titles in hand.
06-04-2012, 04:05 AM #5
17,000 gets both skis .....Very firm
Last edited by icerat4; 06-22-2012 at 01:17 AM.
06-06-2012, 05:40 AM #6
06-09-2012, 03:27 PM #7
ttt i very suprised at this price
06-14-2012, 09:53 AM #8
Will seperate the skis 8g each. These skis are located in ILLINOIS..
06-15-2012, 05:06 PM #9
Last edited by icerat4; 06-22-2012 at 01:18 AM.
06-19-2012, 07:16 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)