Results 1 to 6 of 6
  1. #1
    skigolfnut's Avatar
    Join Date
    Jun 2009
    Location
    League City TX
    Posts
    1,979
    +1
    33

    RXP bellows shaft bearing questions

    I just followed the sticky's and MSRXP post on removing the drive shaft and bellows and C clip,
    the bearings that are on the pto end did come out a little bit when the drive shaft came out,
    do I put them in now with no shaft or put them on the end of the shaft when I go back in with everything?
    thanks,


  2. #2
    83.0 @ 8400 jhill19's Avatar
    Join Date
    Jul 2010
    Location
    Teays Valley, West Virginia
    Posts
    2,800
    +1
    81
    You can put them on right before you put the shaft on bc most likely it will just fall off again

  3. #3
    skigolfnut's Avatar
    Join Date
    Jun 2009
    Location
    League City TX
    Posts
    1,979
    +1
    33
    so when going back in with everything I put them on the end of the shaft and they should be good?

  4. #4
    83.0 @ 8400 jhill19's Avatar
    Join Date
    Jul 2010
    Location
    Teays Valley, West Virginia
    Posts
    2,800
    +1
    81
    Sure.

  5. #5
    Chris crisistc's Avatar
    Join Date
    Jul 2009
    Location
    Savannah, GA
    Posts
    295
    +1
    4
    We just did the same thing today, we had to beat the shaft with a hammer to get it off and the bearing just came out of the pto housing, I think that is why it was leaking oil so bad...

  6. #6
    skigolfnut's Avatar
    Join Date
    Jun 2009
    Location
    League City TX
    Posts
    1,979
    +1
    33
    MSRXP just confirmed that it is normal for the bearing to come out when the drive shaft comes out, and that the grove on the shaft holds it in place when it is all back together,

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Spun balance shaft bearing 2008 RXP-X
    By Water Pig in forum 4-Tec Performance
    Replies: 4
    Last Post: 09-05-2012, 09:52 AM
  2. RXP jet pump bearings.. Question
    By RXPteamtimebomb in forum 4-Tec Performance
    Replies: 12
    Last Post: 03-10-2012, 03:15 AM
  3. inter shaft bearing question
    By Hydrotherapy in forum Yamaha PWC Performance (2-stroke)
    Replies: 8
    Last Post: 10-25-2007, 01:15 PM
  4. Installed RXP new grate , have Questions??????
    By chris7613 in forum 4-Tec Performance
    Replies: 2
    Last Post: 04-24-2006, 09:02 AM
  5. Finally got to ride my 05 Rxp and have some questions.
    By Mark S in forum 4-Tec Performance
    Replies: 10
    Last Post: 06-17-2005, 06:40 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •