Thread: Clamping Kana-Flex
01-21-2007, 11:53 PM #1
A question for those who've used this stuff...
What kind of clamp/s have you used? I was wondering if there'll be a problem with air bleeding out at the couplings/filter et al. ...because of the corrugation on the outside of the hose.
01-22-2007, 01:13 AM #2
air wont bleed out... it's on intake side of the SC.... always under vaccuum, so if it didn't clamp nice, air will still be getting sucked in...
here's a tip.... the hose has a metal wire helic coil within the hose walls... go back maybe 2" and snip the wire coil within the hose and work it out one end.... now you have 2" of soft rubber to evenly clamp and squick for a good seal
01-22-2007, 10:46 AM #3
01-22-2007, 06:51 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Dockside in forum 4-Tec PerformanceReplies: 13Last Post: 01-12-2010, 06:07 PM
By Pale Rider in forum Sea Doo Open DiscussionReplies: 5Last Post: 09-24-2008, 01:57 PM
By VaRedneck in forum 4-Tec PerformanceReplies: 30Last Post: 02-10-2007, 03:46 AM
By Pale Rider in forum 4-Tec PerformanceReplies: 13Last Post: 03-05-2006, 02:53 PM
By Jrsrxp in forum 4-Tec PerformanceReplies: 11Last Post: 05-24-2005, 07:57 AM