Thread: O2 Sensor question
06-09-2012, 11:28 AM #1
O2 Sensor question
Does everybody remove their O2 sensor on a regular basis? you only use to tune and thats all, not to monitor? If you use this heat sink bung on the j-pipe install will that protect it better and allow you to leave it in for monitoring purposes? I ordered this setup... http://www.dynotunenitrous.com/store...?idproduct=150
Will this allow you to leave in the sensor?
Didn't realize you could only use to tune...then had to pull it...Any input is appreciated! I've put 92 hours on my 2006 rxp since new. How many hours before you burn up an O2 sensor?
06-09-2012, 11:33 AM #2
I leave mine in three seasons same sensor
06-09-2012, 11:52 AM #3
06-09-2012, 12:50 PM #4
06-09-2012, 01:14 PM #5
I'm running mine for 2 seasons now,still perfect.
06-09-2012, 08:11 PM #6
Some fear the water will foul the wide band senor.
Everything on a ski is expensive whats another $100 sensor now and again?
Totally your own preference.
06-10-2012, 09:56 AM #7
I run mine all season,just take it out during the winter months..
06-10-2012, 06:24 PM #8
Mine is in for 2 seasons and 160 hrs. No problems.
06-11-2012, 08:08 AM #9
Sorry I didn't answer. Weekend was to good of weather not to ride...I'm sure you all understand! Anyways, Are all of you running them in the j-pipe except for eric?
06-11-2012, 10:11 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)