Results 1 to 3 of 3
  1. #1
    Chine Walker
    Join Date
    Nov 2006

    does anyone remember the install steps for the RPM couplers?

    I'm trying to get the coupler to fit in between the PV shafts, but no matter what side I start it won't side over..the opposite end (shaft). Does anyone remember the install sequence?? These are the spring loaded ones that I believe Isanediegojoe sold a while back..


  2. #2
    Moderator OsideBill's Avatar
    Join Date
    Mar 2006
    United States
    you have to remove the small silver end caps and slide them on first. Then shove the spring loaded side on abd drop back onto the other shaft

  3. #3
    Chine Walker
    Join Date
    Nov 2006

    I have the caps off & on the shaft, but not sure why the "cut-out" side doesn't go in enough so I can slip over the short shaft side??


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. does anyone know the part num i need it for a walbro fuel pump
    By starter99 in forum 4-Tec Performance
    Replies: 3
    Last Post: 05-23-2011, 03:43 PM
  2. Does anyone know the carb float spec for a 900 ZXI
    By chvscks319 in forum Kawasaki Open Discussion
    Replies: 0
    Last Post: 08-30-2010, 01:39 PM
  3. Does anyone in the chicagoland area do valvetrain work for $$
    By RXPSTUNNA in forum 4-Tec Performance
    Replies: 4
    Last Post: 08-11-2010, 03:01 PM
  4. Does anyone know the squish measuremt for a stock 1300 head?
    By jpa1300 in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 06-08-2008, 10:25 PM
  5. Does anyone make a reliable Powervalve for the 1200's?
    By snowrunner in forum Yamaha PWC Performance (2-stroke)
    Replies: 14
    Last Post: 05-18-2007, 04:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts