06-23-2012, 02:43 PM #1
jet ski sunk wont do any thing now
hi i have gp1300r that i went out on yester day. i was jumping some waves when my exhaust got out of place and was letting water get in. i noticed so i shut it off and pulled it to shore. i took all the water out of the haul but when i went to start it again to see if it has water in the cylinder which it might have it wouldnt do any thing.am guesing it has to do with some thing electrical because where the fuse go it had some water coming out of it. can any body tell me what wrong with it. thank you
Last edited by joeny; 07-02-2012 at 01:23 PM.
06-23-2012, 05:05 PM #2
im not jet ski expert but if its not doing anything, id check for a fuse or something to see if its blown..usually they take the place of something more expensive blowing.
06-23-2012, 06:08 PM #3
electrical box might of filled with water, take out the round fuse cover and see if water comes out of it.
06-23-2012, 06:35 PM #4
07-01-2012, 01:27 PM #5
I changed the relay to the starter and now the starter is working but the engine is make a weird sound like if some thing is turning but its not starting what should i check or change
07-01-2012, 01:36 PM #6
- Join Date
- Apr 2010
- Greenville, NC
Did you take the plugs out and turn it over to make sure you did not get any water in the motor?
07-02-2012, 07:03 AM #7
- Join Date
- Oct 2005
sounds like it is done, stick a fork in it...
water ingestion needs to be addressed immediately. in your case, you could not turn over the ski to push any water out thru the plug holes, and "burn" the water off by refiring and riding the ski hard.
Water in the electrical box is not good by any means... usually that is sealed pretty well.
and your saying that water also got in the fuel tank...
at the very least pull the plugs and turn the motor over by hand at the coupler, looking for water in the cylinders. either way sound like some time has passed and the crank bearings do no like water... good luck. at least you`ll be able to determine what your next move is after checking...
07-02-2012, 01:22 PM #8
K i got the water out of the cylinder but now the two back cylinders have 150psi and the front has 50 psi what should i do
07-02-2012, 05:24 PM #9
07-02-2012, 05:25 PM #10
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)