Results 1 to 5 of 5
  1. #1

    2002 GTX DI Maintnance light

    No beeps, no limp mode, runs fine. Any ideas or does it just need the BUDS reset?


  2. #2
    holding the SET button on a carb model resets the light, no sure about DI models.

  3. #3
    SURFnTURF's Avatar
    Join Date
    May 2007
    Location
    Australia
    Posts
    878
    +1
    11
    To clear the warning message while it is blinking:

    1. Press and hold The SET for 2 seconds to reset

    NOTE: If maintenance message (MAINT) continues
    to blink, it indicates a fault with the fuel injection
    system on Di models. Refer to DIAGNOSTIC
    PROCEDURES section.





    If your battery is low it will flash maintenance until it comes up to the proper voltage.

    Some do this for the first 30sec - 1 min then it goes away.

  4. #4

    Join Date
    Oct 2010
    Location
    arlington tx
    Posts
    1
    anybody have any idea if there is a replacement fuel pump for a 2002 gtx di i bought an use one last year an i need another one.i dont want to buy an use one and the original is to spensive.

  5. #5
    Blackhawk36's Avatar
    Join Date
    Apr 2012
    Location
    Maryland, USA
    Posts
    144
    +1
    1
    There are some options here. You need to take the baffle apart, replace the pump and reassemble but you save a lot of money.

    http://www.greenhulk.net/forums/show...ghlight=walbro

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 9
    Last Post: 08-08-2010, 01:40 PM
  2. 2002 Gtx Di, Immaculate, New engine w/ warranty
    By NoMo-xp4me in forum Sea Doo Classifieds
    Replies: 2
    Last Post: 06-20-2008, 09:16 AM
  3. is a 2002 gtx-di a good ski?
    By sic fish in forum Sea Doo Open Discussion
    Replies: 2
    Last Post: 09-04-2007, 08:44 PM
  4. 2002 GTX DI won't run above idle in water
    By zone 5 in forum 2-Stroke Performance
    Replies: 2
    Last Post: 08-26-2007, 06:53 PM
  5. 2002 GTX DI MAintenece code?
    By Big Jay in forum 2-Stroke Performance
    Replies: 1
    Last Post: 05-10-2007, 08:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •