Results 1 to 7 of 7
-
06-29-2012, 11:19 PM #1
- Join Date
- Jun 2006
- Location
- Riverside,ca
- Posts
- 4,979
- +1
- 23
I need a solas 15/22 measurement please
If you have an untouched 15/22 can you set it on a flat surface & measure the gap between the trailing edge corner and the surface? How many MM's is it? I have a few 15/22's here and there's a 3+mm difference between them.
Thanks
-
06-29-2012, 11:58 PM #2
- Join Date
- Mar 2008
- Location
- Whyalla, South Australia
- Posts
- 1,947
- +1
- 20
Jim, I'm getting 73.5mm
-
06-30-2012, 12:12 AM #3
- Join Date
- Jun 2006
- Location
- Riverside,ca
- Posts
- 4,979
- +1
- 23
??
I need the bottom trailing edge sharp corner nearest the surface... should be a few mm. Sounds like you measured the leading (top) edge..
Thanks!
-
06-30-2012, 12:47 AM #4
- Join Date
- Jun 2006
- Location
- Riverside,ca
- Posts
- 4,979
- +1
- 23
Like this..
-
06-30-2012, 12:55 AM #5
- Join Date
- Mar 2008
- Location
- Whyalla, South Australia
- Posts
- 1,947
- +1
- 20
Okay, my bad. 5mm
-
06-30-2012, 01:45 AM #6
- Join Date
- Jun 2006
- Location
- Riverside,ca
- Posts
- 4,979
- +1
- 23
thanks!
-
06-30-2012, 03:26 AM #7
- Join Date
- Mar 2008
- Location
- Whyalla, South Australia
- Posts
- 1,947
- +1
- 20
No probs.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
