Results 1 to 2 of 2
  1. #1

    Join Date
    Jun 2012
    Location
    Tempe, AZ
    Posts
    12

    How do I torque the carbs in the hull on a 95 slt750?

    I am new to polaris and I am holding off rebuilding the cards on both my 95 slt and sl 750's because I don't know the proper or best way to torque them back in properly with the limited space, is there a certain offset tool? or do I need to pull the engines out torque then reinstall? can someone please shed some light on this procedure?


  2. #2
    She likes the bike. But the ski gets her wet!!!! xlint89's Avatar
    Join Date
    Oct 2006
    Location
    Cleveland OH
    Posts
    17,327
    +1
    29
    Short 12mm wrench. You'll never get a torque wrench on the nuts inside the hull.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How do I torque the carbs in the hull on a 95 slt750?
    By metalshack in forum Polaris Open Discussion
    Replies: 1
    Last Post: 07-01-2012, 09:40 PM
  2. how do you split the hull on a kawasaki 650sx?
    By BADSL900 in forum Kawasaki How To & FAQs
    Replies: 0
    Last Post: 06-09-2011, 10:28 PM
  3. How do you remove the STARTER on a 96 XP?
    By BartenderSmalley in forum Sea Doo Open Discussion
    Replies: 8
    Last Post: 08-04-2008, 02:27 PM
  4. How do I remove the coupling on the driveshaft!?
    By RideBlue in forum Kawasaki How To & FAQs
    Replies: 5
    Last Post: 01-18-2008, 01:01 PM
  5. How do you fix the TIme on the forum
    By brad2510 in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 09-02-2007, 01:29 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •