Results 1 to 4 of 4
  1. #1

    1995 XP rear shaft removal help PLZZZZ

    Hello,

    need a little help with getting the rear shaft out. The engine is the smaller one, 725cc??

    Have the rear housing off and alm looking at the rear shaft with a flat machined into it. 17mm wrench fits it.

    Do I unscrew it counter-clockwise?

    Where do I hold onto the other end to unscrew it?

    Thanks for any help, Jim


  2. #2
    AndinoWatercraft's Avatar
    Join Date
    Feb 2008
    Location
    Puerto Rico
    Posts
    306
    +1
    4
    If you are trying to remove the driveshaft and already remove the pump could be a little dificult because of the ''C '' clip before the carbon seal (not sure for that year if it uses that or the carrier one) Withe te pump back in place pull back the carbon seal and the holder to remove the ''C'''clip that is put on the shaft. With out that clip removed the shaft will not come out.

    In other hand if what you need to remove is the PTO it unscrews counter clockwise. One trick is to remove the spark plugs and slide a piece of rope inside the cyl and turn until it stucks then turn the PTO using the tool for it. IMO this move it's done when replacing the crank seals . What are your plans?

    Guys correct me if I'm wrong.

  3. #3
    LOL Thank you very much for your reply.
    From what I can understand, I will do the rope in the cylinder trick and try to unscrew the shaft.
    Thanks, Jimb

  4. #4
    AndinoWatercraft's Avatar
    Join Date
    Feb 2008
    Location
    Puerto Rico
    Posts
    306
    +1
    4
    Did you get it out ?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. rxp x pump housing shaft removal help !!
    By supra_power2 in forum Sea Doo How To & FAQs
    Replies: 1
    Last Post: 10-16-2013, 08:11 AM
  2. 2005 Seadoo RXP 215 PTO shaft Removal HELP!
    By cool34 in forum Sea Doo How To & FAQs
    Replies: 1
    Last Post: 05-17-2013, 09:29 PM
  3. FX HO drive shaft removal help
    By mewaschuk in forum Yamaha PWC Performance (4-stroke)
    Replies: 3
    Last Post: 08-26-2011, 07:11 PM
  4. Drive shaft removal help wont come out!!!
    By theking549 in forum 4-Tec Performance
    Replies: 2
    Last Post: 10-16-2010, 06:51 PM
  5. 96 xp pump removal help
    By 5Bulldogs in forum 2-Stroke Performance
    Replies: 5
    Last Post: 07-07-2008, 02:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •