Results 1 to 7 of 7
  1. #1

    Join Date
    Jun 2009
    Location
    Tierra Verde, Florida, United States
    Posts
    911
    +1
    17

    Hull Bellows fitting repair?

    Has anyone ever had to repair the hull wear the bellows clamps to? I just bought 05 RXT that had broken motor mounts causing the drive shaft to wear out about 1/4 of the cylinder wear the bellows clamps. Has anybody fixed this and if so what did you use? Thanks for the help


  2. #2
    mac_man_luke's Avatar
    Join Date
    Sep 2010
    Location
    South Australia
    Posts
    1,262
    +1
    22
    Iv seen a billet replacement that can be epoxed in, not sure where that was though!

  3. #3
    ou812's Avatar
    Join Date
    Jun 2006
    Location
    Riverside,ca
    Posts
    6,210
    +1
    198
    It shows this repair procedure in the Shop manual in detail. There's a part #...

  4. #4

  5. #5

    Join Date
    Jun 2009
    Location
    Tierra Verde, Florida, United States
    Posts
    911
    +1
    17
    Quote Originally Posted by ou812 View Post
    It shows this repair procedure in the Shop manual in detail. There's a part #...
    thanks but I can't find a part #

  6. #6

    Join Date
    Jun 2009
    Location
    Tierra Verde, Florida, United States
    Posts
    911
    +1
    17
    this is the smaller bellows hole like on the GTX's

  7. #7
    Got Boost? psycho rxp's Avatar
    Join Date
    Jul 2005
    Location
    Port St. Lucie, FL
    Posts
    5,445
    +1
    182
    SBT sells what looks like a Brass thru hull fitting...

    http://www.shopsbt.com/jet-ski-jetpu...76-112-07.html

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Hull damage and repair pics and custom paint
    By speedskixp in forum Sea Doo Open Discussion
    Replies: 100
    Last Post: 11-01-2011, 09:40 PM
  2. hull tru fitting anybody help
    By keith neff in forum Sea Doo Open Discussion
    Replies: 0
    Last Post: 08-03-2008, 11:05 AM
  3. Through Hull Exhaust Fit The X Models?
    By mstennes in forum 4-Tec Performance
    Replies: 5
    Last Post: 07-13-2008, 08:38 PM
  4. where to get through hull exhaust fitting
    By BoostedH23a1 in forum 4-Tec Performance
    Replies: 23
    Last Post: 05-07-2007, 04:41 PM
  5. Thru Hull Bilge Fitting Placement
    By 1FastTrespiper in forum 4-Tec Performance
    Replies: 12
    Last Post: 04-12-2006, 10:26 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •