Results 1 to 2 of 2
  1. #1

    How much can the block be decked?

    I traced my coolant loss to a small nick in the block inbetween the coolant passage and the cylinder wall. I had a machinist measure it and it is less then half a thou or .00005 " Has anyone milled the top of their cylinders (block) and what would be a safe amount to avoid valve/piston interference.... say .002 if the block wasnt warped?


  2. #2
    boost junkie skidoochris's Avatar
    Join Date
    Mar 2012
    Location
    Davison, Mi
    Posts
    4,494
    +1
    476
    .0005 IMO is not your problem
    tell us your mods... sounds like a blown head gasket from DETO

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 96 gti, how much oil should it be using? can you pre mix?
    By rocksandblues in forum 2-Stroke Performance
    Replies: 2
    Last Post: 07-10-2013, 07:35 AM
  2. How far can the Cylinder base be shaved?
    By Scoobee in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 09-30-2009, 10:31 PM
  3. how much can you deck a 701 head
    By dabeetereater in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 05-05-2009, 06:23 AM
  4. How rough should the idle be?
    By Rio Vista in forum Yamaha Open Discussion
    Replies: 5
    Last Post: 03-13-2007, 01:33 PM
  5. how much does the stock mph gauge vary from being accurate??
    By CarFanatic in forum Sea Doo Open Discussion
    Replies: 11
    Last Post: 06-21-2006, 10:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •