Thread: 1100 no spark or gas
08-12-2012, 09:03 PM #1
1100 no spark or gas
Just finished the 1100 blaster to find out the third cylinder is not getting a spark or gas. Never seen the same cylinder have two different issues. Does anyone have any ideas??? Or where to start looking?
08-12-2012, 11:06 PM #2
You have to treat them as 2 separate problems. The fuel issue is probably carb related. So dig into that carb and see if you can find something.
08-13-2012, 08:14 AM #3
Yea, gonna have to pull them. Might as well cut back the third wire too and try that before I try different electronics.
08-20-2012, 08:47 PM #4
Still can't get a spark out of the third plug. Snipped it back about an inch, put boot back on...nothing. Check solenoids to make sure there was no corrosion, that checks out. Weird because I can still put on the tiny tack around the third wire and turn it over and it is ready to detect rpms once I hit the start button, so it is finding a current. Just stumped.
08-20-2012, 08:53 PM #5
ohm out the stator. Maybe the pulsar coil for #3 is out of spec
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)