Results 1 to 4 of 4
  1. #1

    Water getting in gp760

    Whenever i ride around, i notice that a little bit of water fills up in the yamaha, only after i go pretty fast. There is a little spot on the motor where it looks like the gasket is bad, it left a little water mark, and i'm thinking, could water get out of the cooling thing if the gasket is bad? I know is it not a problem with the hull because it can sit for hours in water and not fill up a drop until i ride around.


  2. #2
    Yamaha artisan Cutlass's Avatar
    Join Date
    Oct 2010
    Location
    Madison, WI, USA
    Posts
    2,500
    +1
    55
    Yes, water can leak out of the cooling system into the hull.

  3. #3
    Is it hard to take off the top end of the engine to replace a seal?

  4. #4

    Re: Water getting in gp760

    also, depending on how bad it is, water may leak into your crankcase. which gasket is it?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Questions on hoses, water getting in rough idle.
    By USAFrider in forum Polaris Open Discussion
    Replies: 3
    Last Post: 05-27-2011, 01:15 PM
  2. Water getting in engine compartment..?
    By Yamahamama in forum Yamaha Old School Skis
    Replies: 5
    Last Post: 09-13-2010, 05:09 AM
  3. How much water gets in?
    By highjynx in forum Sea Doo Open Discussion
    Replies: 11
    Last Post: 06-23-2010, 07:55 PM
  4. RXP-X Water getting in to hull
    By haleyscomet in forum 4-Tec Performance
    Replies: 11
    Last Post: 07-24-2008, 08:53 AM
  5. How does water get in the VTS box?
    By Shibby1485 in forum 4-Tec Performance
    Replies: 4
    Last Post: 11-18-2006, 01:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •