Thread: PTO oil/rotary seal help!!
09-01-2012, 01:05 PM #1
- Join Date
- Aug 2012
PTO oil/rotary seal help!!
OK, so I got the oil seal, and rotary seal pressed in, then also pressed in the water pump shaft supporting the inside part of the seal. When I spin the shaft, it is hard to spin, like it is wearing on the inside part of the PTO case. Is it like this, and the pressure from the water pump floats it between? I attached a pic of where the shaft sits in the seal, just dont know if it is far enough, or too far.... When I hand tight the water impeller, and push it in and spin, the impeller slightly bottoms out on the PTO case... thoughts.... Thanks for any help.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)