09-02-2012, 04:50 PM #1
Difference between fz & fx engine
Ok guy is there thing that is different such as sensors or wiring basicly took a engine out of a fx hull and put in in a fz the ski has a motec ecu it cranks but won't start any ideas?
09-02-2012, 07:28 PM #2
No engines & sensors are identical. ECU differs in Cruise Assist, No Wake, etc.
09-02-2012, 09:00 PM #3
I just thought it could be a sensor that was related to the cruise or no wake but if there the all the same I can tick that off things to check
09-02-2012, 10:18 PM #4
Do you have access to the FZ ECU? You might try swapping that out to see if it will fire up. More than likely is unrelated to the ECU. Was the Motec set up for the engine you're using it with?
09-03-2012, 12:31 AM #5
phil did you replace the part under the front hatch ( the security key bit) with the motec part
if you didn't you can put the stock computer back in and unlock it with the remote
you can then put the motec back in and start it
09-03-2012, 12:33 AM #6
just so you know it will lock with the stock ecu disconected
but it will not unlock unless the stock ecu is conected
09-03-2012, 03:52 AM #7
Well dose anybody know if there a different flywheels such as the amount of polls on it?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Adam in forum Yamaha PWC Performance (4-stroke)Replies: 3Last Post: 04-16-2012, 09:24 PM
By darakuja in forum Sea Doo Open DiscussionReplies: 3Last Post: 08-01-2011, 08:21 AM
By tmc84 in forum 4-Tec PerformanceReplies: 30Last Post: 08-07-2007, 12:02 PM
By JRW1484 in forum 4-Tec PerformanceReplies: 10Last Post: 02-16-2006, 08:51 AM
By Compwhiz82 in forum Sea Doo Open DiscussionReplies: 14Last Post: 11-04-2005, 01:20 PM