Thread: Thru hull shaft size comparison?
09-04-2012, 11:37 PM #1
Thru hull shaft size comparison?
Does anyone know the shaft size of the old seadoo shaft bearing seal -thru hull?
not the ones that use the carbon ring and hat and C clip, but the ones that use the greased bearings and hose clamps?
I saw that seadoo made several years of them for older skis than the 06 RXP, but was wondering what the shaft size was?
I have a good SKF S/S bearing guy that can match any Ball Bearing made in Stainless Steel for salt water use,
I want to retro fit an older style set up for my 06 RXP and I know I need to put the shaft on a lath and cut it to the desired OD to fit the bearings,
09-05-2012, 06:36 AM #2
I have the entire set up in stock..Bearing carrier, bearings, seals..All ready to drop into the accordian boot
09-05-2012, 07:36 AM #3
09-05-2012, 12:57 PM #4
This assembly replaces the accordian boot...It retails for $295.00
I also have it in a red annodized color
09-06-2012, 07:31 AM #5
do I have to mill the shaft to fit the bearings?
09-06-2012, 07:50 PM #6
Let me check tomorrow and I will let you know for sure!!!!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By RobWCanada in forum 4-Tec PerformanceReplies: 12Last Post: 05-12-2011, 09:35 PM
By poof100 in forum Yamaha PWC Performance (4-stroke)Replies: 16Last Post: 07-11-2010, 05:16 PM
By johnsonmtz in forum Polaris ClassifiedsReplies: 5Last Post: 07-05-2010, 10:36 PM
By Bone1050 in forum Polaris ClassifiedsReplies: 2Last Post: 06-21-2010, 06:23 PM
By Compwhiz82 in forum 4-Tec PerformanceReplies: 21Last Post: 06-25-2005, 11:08 AM