10-21-2005, 12:46 PM #1
If it isn't one thing it's another....
the stupid 2.75 drill bit doesn't fit in my drill. None of my neighbors have tools so I now have to drive over to my dad's and see if his drill is bigger then mine (hehe) Don't tell me I'm going to have to buy a new drill, maybe I can just buy a new chuck to go on the drill.
10-21-2005, 12:49 PM #2
Buy a drill with a 1/2 inch chuck at Sears, carefully use it to drill the hole, then clean it up and return it...no harm done to the drill or your pocketbook...or drive to FL and I will lend you one.
10-21-2005, 02:31 PM #3
Or put the drill but on the grinder and grind away the part of the bit where it goes into the chuck, and that will work fine.
Try to be symmetrical with your grinding
10-21-2005, 02:45 PM #4
thats exactly what i did Jeff.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MJE in forum Yamaha ClassifiedsReplies: 22Last Post: 06-05-2010, 11:17 AM
By seaobin in forum Polaris Open DiscussionReplies: 16Last Post: 12-12-2008, 05:02 PM
By Chrisrokc in forum Open DiscussionReplies: 16Last Post: 09-29-2008, 05:16 PM
By Pwgsx in forum Sea Doo Sport BoatsReplies: 2Last Post: 09-19-2007, 12:16 AM
By RXPED in forum 4-Tec PerformanceReplies: 11Last Post: 09-01-2006, 12:13 AM