Thread: Ride Plate mod.
02-06-2007, 02:07 PM #1
Ride Plate mod.
I fyou look at this picture you will see two copper washers where the ride plate meets the hull.
After testing stock Im gonna rip these bad boys out. Then reseal the crappy silicone job the Factory did.
02-06-2007, 02:57 PM #2
measure them to see how thick they are. If they measure 40 thousands that will raise your angle by two times the measurement. You will also have to make sure the plate clears the pump without them in.
02-06-2007, 11:29 PM #3
Hmmnnnn, might that be one quick way to start getting the nose out of the water and get some speed?? I hope so..........
02-07-2007, 12:57 AM #4
Aftermarket plate will lift the nose and add a MPH Its all ading up!!!!
02-07-2007, 10:28 PM #5
- Join Date
- Sep 2006
- S. Florida
We need baselines.
02-08-2007, 03:26 AM #6
02-08-2007, 05:06 AM #7
02-08-2007, 06:08 AM #8
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Tanny in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 02-17-2007, 09:09 PM
By BULLRAIDER in forum Yamaha Old School SkisReplies: 10Last Post: 01-09-2007, 07:02 AM
By nitro rxp in forum 4-Tec PerformanceReplies: 3Last Post: 08-13-2005, 01:00 PM
By 01xdime in forum 4-Tec PerformanceReplies: 8Last Post: 08-11-2005, 02:43 PM
By Krazy-K in forum 4-Tec PerformanceReplies: 8Last Post: 06-21-2005, 05:10 PM