09-20-2012, 06:12 AM #1
Steps: Trimming iBR Neutral Position
Trimming iBR Neutral Position:
Hey guys. I came across this tip while reading the owner’s manual again.
Also came across a person on youtube complaining about Sea-Doo and how 'the Neutral doesn't actually work'.
I think he just doesn't realize ( didn't read the manual ) the Neutral position on iBR skis can be trimmed.
For those who think their Neutral does not function properly, or if you'd like to fine tune your Neutral position,
please see the steps below from the Owner’s manual:
How to Trim the Neutral Position of
the iBR When in NEUTRAL, if the watercraft
creeps forward or backward, the iBR
system may be trimmed.
NOTE: Movement of the watercraft
when operating in neutral may be due
to wind or water current.
If the watercraft is moving forwards,
momentarily press the DOWN arrow
If the watercraft is moving backwards,
momentarily press the UP arrow button
Hope that helps.
09-20-2012, 01:44 PM #2
Did you tell him to read his manual and that would tell him how to fix it? Ill bet he never thought to look at the manual at all,I always look at my manual just to refresh myself on all the things my ski has and how to fix simple things like his problem.
09-20-2012, 02:43 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vman in forum 4-Tec PerformanceReplies: 7Last Post: 03-21-2012, 02:21 PM
By wave15stx in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 09-03-2010, 09:05 AM
By chopper901 in forum Polaris Open DiscussionReplies: 9Last Post: 04-14-2009, 10:18 PM
By rx4pain in forum Sea Doo Open DiscussionReplies: 6Last Post: 11-24-2008, 08:42 AM
By Green Hornet in forum 4-Tec PerformanceReplies: 4Last Post: 12-13-2005, 09:27 AM