Results 1 to 2 of 2
  1. #1

    Join Date
    Aug 2011
    Location
    san juan capistrano ca.
    Posts
    38

    Red face 01 xlt 1200 2 stroke

    hello ,i have a 2001 yam. xlt 1200 2 stroke last time i road it it was boging bad changed plugs & fuel filter with no change , with it ideling i pulled off one spark plug wire at a time cylinder #1 was dead , has good spark, compression 100psi x3 comp. ratio 5.9to one seems ok, so must be the carbs right pulled the carbs off fuel pumps seem ok so i will rebuild the carbs , any body done those before , also catilitic converter looks good ,but i will be replacing it with a d plate and chip.


  2. #2
    Formerly Ultra250 TN Aquaholic6801's Avatar
    Join Date
    Feb 2007
    Location
    Old Hickory,Tn
    Posts
    5,446
    +1
    650
    Might get a little more response in the 2 stroke section......

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. '01 XLT 1200 2 stroke oil leaking
    By Vellocity in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 03-26-2008, 10:57 PM
  2. Jet settings and needle screws ('01 XLT 1200)
    By Jolly Roger in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 09-06-2007, 02:24 PM
  3. My worst fears are confirmed. ('01 XLT 1200)
    By Jolly Roger in forum Yamaha PWC Performance (2-stroke)
    Replies: 15
    Last Post: 07-25-2007, 10:58 AM
  4. Crankshaft on an '01 XLT 1200
    By Jolly Roger in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 07-22-2007, 04:19 PM
  5. '01 Xlt 1200 Hot Start Problem
    By belgianhead in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 05-09-2006, 11:08 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •