Thread: 1100 blaster cdi issue.....
10-17-2012, 11:25 PM #1
1100 blaster cdi issue.....
well i was getting everything together for wavedaze in va beach and go to start the ski and it started but was running bad , it would run for 30 sec then die , a buddy came by that works on skis , and he said it was a fuel issue , take carb covers off and he sprayed some carb cleaner in the carbs when it died again on the next start up of 30 sec.
i removed the cdi box cover and found the starter wire had rubbed the case and all the small red wires were fused together(melted) and a ground was burnt with them..
the external vlt reg was HOT,like burn your finger HOT.
I REPLACED the wires with new ones and put a new vlt reg on....
tried starting it.....same thing again 30 sec
changed the coil pack....same thing
the spark goes from bright blue...to a fade of nothing...in that 30 seconds...plugs are wet
it happens on all the plugs......
hope someone has had these issues and can help a fellow skier out....i want to backie this thing!!!...it ripped on saturday...i just dont understand.....
i have a 65u cdi ..will it work?
10-18-2012, 06:30 AM #2
i leave tonight.............bump
10-23-2012, 10:24 AM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Speedn in forum Yamaha ClassifiedsReplies: 11Last Post: 10-16-2010, 10:17 PM
By andy95'slx780 in forum Yamaha ClassifiedsReplies: 5Last Post: 09-27-2010, 10:46 AM
By DANGER1049 in forum Yamaha Old School SkisReplies: 2Last Post: 03-13-2008, 08:14 AM
By dav_dman in forum Yamaha Old School SkisReplies: 1Last Post: 07-08-2007, 04:07 PM
By RichGPR in forum Yamaha PWC Performance (2-stroke)Replies: 14Last Post: 11-21-2005, 07:16 PM