Thread: Low oil buzzer questions.
02-11-2007, 02:00 PM #1
Low oil buzzer questions.
Ok as many of you know I removed my oil tank. So my question is this. Do I need to install a resistor to the two wires going to the sender, or can I just leave the wires alone. I would go and check the ohms on the unit but it is just too damn cold.
02-11-2007, 02:16 PM #2
Install a 33 ohm resistor in the electrical box.
02-11-2007, 02:17 PM #3
02-11-2007, 02:26 PM #4
If you don't want to split the box you can also solder the resistor at the removed sender wires and use heat shrink on it.
I'll usually do the heat shrink until I have to split the box for some reson.
02-13-2007, 10:23 PM #5
On my '92 SL650 I didn't get a buzzer when I unplugged the oil tank wires. So does this mean my buzzer is defective, and won't work on the temp either? Never tested it before.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By docricky in forum Kawasaki PWC Performance (4-stroke)Replies: 2Last Post: 05-21-2012, 10:03 AM
By zone 5 in forum 4-Tec PerformanceReplies: 2Last Post: 09-15-2008, 10:41 PM
By seadoo951 in forum 2-Stroke PerformanceReplies: 5Last Post: 04-15-2007, 08:42 PM
By CarFanatic in forum 4-Tec PerformanceReplies: 4Last Post: 07-24-2006, 03:41 PM
By rxp_boy in forum 4-Tec PerformanceReplies: 4Last Post: 05-23-2005, 10:03 AM