Results 1 to 4 of 4

Thread: Carbon ring?

  1. #1

    Carbon ring?

    i have been reading on about "carbon ring" problems. how can i check if mine is fine? 07 rxp.


  2. #2
    wettank's Avatar
    Join Date
    Mar 2011
    Location
    St Louis
    Posts
    211
    How many hours,are you cativating,is there water in the hull,do you see any carbon dust that has flung onto the the hull?
    When in doubt replace it all!

  3. #3
    60 hours. A bit of water. Didn't notice any dust.
    My engine is out, but I did not remove driveshaft. I just pulled engine forward and got it out

  4. #4
    wettank's Avatar
    Join Date
    Mar 2011
    Location
    St Louis
    Posts
    211
    I would go ahead and replace while the engine is out.It will make things a little easier and it will be due to be replaced anyway.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Driveshaft too far forward. Can't seal Carbon ring.
    By ccassone in forum 2-Stroke Performance
    Replies: 4
    Last Post: 08-28-2006, 08:41 AM
  2. Carbon Ring Install
    By moultrie rxp in forum 4-Tec Performance
    Replies: 3
    Last Post: 07-31-2006, 03:21 PM
  3. Carbon ring replacement HOW TO?
    By Jeff C in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 05-22-2006, 11:31 PM
  4. Carbon ring replacement?
    By Rendog in forum Sea Doo Open Discussion
    Replies: 7
    Last Post: 01-02-2006, 07:06 PM
  5. Reinforcement of pump tunnel area around carbon ring
    By Green Hulk in forum 4-Tec Performance
    Replies: 12
    Last Post: 08-03-2005, 03:13 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •