Thread: exhaust mid pipe clamp size
11-26-2012, 11:59 AM #1
exhaust mid pipe clamp size
Keep blowing it off. Anyone got a caliper handy or know the diameter off hand? is it 3" diameter? Looking at this http://www.ebay.com/itm/1PC-2-75-70m...49eba4&vxp=mtr
11-26-2012, 08:11 PM #2
the 08 and up mid pipe hose is 4"diameter,
11-26-2012, 10:25 PM #3
i dont understand how you could blow that off, its jammed between the water box and mid pipe
Also really should not have any pressure on it unless thee exit is blocked somewhere.
11-27-2012, 07:50 AM #4
11-28-2012, 08:47 AM #5
11-28-2012, 08:53 AM #6
junk hose or just add some high temp silicone
11-28-2012, 08:56 AM #7
I have a silicon coupler but the hose clamp is blowing off. I'm looking for the diameter of the J-Pipe so I can t-bolt it. It would save me from buying a caliper.
11-28-2012, 11:44 AM #8
Are you speaking about where the J pipe enters the water box?
I am pretty sure that the ID is 2.5 inches, and you would need aprox 2.75 inch clamp.
3 inch would be too big from what i recall.
What kind of clamp are you using now??
11-28-2012, 02:21 PM #9
11-28-2012, 07:32 PM #10
Hose is 2 3/4.
Hose on J pipe Measures right at 3 inch so need clamp for right under 3 inch or 75 m.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jhill19 in forum Sea Doo ClassifiedsReplies: 2Last Post: 10-11-2012, 07:39 PM
By speedskixp in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-19-2011, 09:05 PM
By ou812 in forum Sea Doo ClassifiedsReplies: 2Last Post: 09-27-2010, 09:15 PM
By ou812 in forum Sea Doo ClassifiedsReplies: 0Last Post: 09-27-2010, 01:33 PM
By Snoman in forum Sea Doo ClassifiedsReplies: 0Last Post: 03-28-2010, 11:32 AM