12-01-2012, 03:21 AM #1
08 RXPX Riva Handle bar drop issue or not..
Ive just installed the Riva RXPX handle bar drop kit.
Since installing it, I put the key in to start, Motor starts.
I pull the key to kill the motor, but the motor is still running.
Is this a Product/my install issue or another under line issue. No fault codes come up on the dash also.
Any input would be great.
12-01-2012, 04:17 AM #2
Richie, i would say you have an under lining issue somewhere else? I had one on my 08 px and i think the only thing that could have happend is when you move the dess post to the new location, i had to pull on the wires pretty tight to get them to bend/kink so it would fit in the dess holder!(broken wire?)
Appart from that all that had to be done was undo the 2 retaining rings, 1 on the buzzer 1 on the dess post so i can't see you have done the install wrong!!
You will like the lowerd feel alot better, just a tip; make sure the bars are straight when you open the front hood!! My hood used to hit the bars if they wern't straight!!
I got the kit for sale if you need another?
12-01-2012, 05:00 AM #3
- Join Date
- Jun 2008
- GREECE ATHENS , NAXOS
Sounds a bad dess post to me.I had the same issue on a couple RXPs and RXPXs!
12-01-2012, 05:28 PM #4
Thanks , I will pull it all apart again to inspect it and see how the wires are.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By cbrseadude in forum Sea Doo Open DiscussionReplies: 3Last Post: 04-08-2012, 11:50 PM
By peterj59 in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 11-09-2011, 03:21 PM
By greasyginzo in forum 4-Tec PerformanceReplies: 10Last Post: 04-25-2008, 10:52 AM
By 007rxp in forum Sea Doo Open DiscussionReplies: 3Last Post: 12-01-2007, 05:18 PM
By green_head in forum 4-Tec PerformanceReplies: 0Last Post: 09-18-2006, 08:25 PM