Thread: Riva Power Cooler Maintenance
12-01-2012, 12:26 PM #1
Riva Power Cooler Maintenance
So i took my power cooler out, cleaned it, put it back together again BUT...
What is the torque spec for the 8 nuts to be tightened around the upper housing? I am using a digital torque wrench that reads Nm's, in.lbs, and ft.lbs
Called Riva, but their answer was,... " 14 in.lbs and go from there..." not sure to where though. I will pressure test up to 20 psi prior to re-installation.
Thanks in advance.
12-01-2012, 01:34 PM #2
12-02-2012, 05:03 PM #3
12-02-2012, 05:18 PM #4
- Join Date
- Jan 2008
- Currituck, North Carolina, United States
NICE JOB MONTY......people were wondering.......should be a STICKY!!
12-02-2012, 08:18 PM #5
- Join Date
- Sep 2007
- Littleton,NC on Lake Gaston
Great info Monty.
12-02-2012, 09:04 PM #6
And don't forget to torque in a criss cross patern
12-03-2012, 05:50 AM #7
03-07-2013, 10:04 PM #8
Thx! for the info and posting some pics! Seems there are no large format pics on the entire web! talk about a camera shy intercooler.
03-07-2013, 10:13 PM #9
Yes it is. Its a great intercooler to break down and clean up. Few offer that option, the only part that sux about it is the BOV install.
03-07-2013, 10:44 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Therock in forum 4-Tec PerformanceReplies: 3Last Post: 07-19-2008, 08:09 PM
By Therock in forum 4-Tec PerformanceReplies: 1Last Post: 07-16-2008, 05:05 PM
By shhr in forum 4-Tec PerformanceReplies: 11Last Post: 08-08-2006, 06:20 PM
By GPR/STX-15F/RXT in forum 4-Tec PerformanceReplies: 12Last Post: 04-28-2006, 09:42 PM
By RXPNJ in forum 4-Tec PerformanceReplies: 1Last Post: 04-21-2006, 11:21 AM