12-05-2012, 09:48 AM #1
- Join Date
- Oct 2012
Aftermarket Wear Ring Replacement on 2006 Seadoo GTX?
New to PWC and this is my first wear ring replacement. Iremoved the 4 wear ring retainer screws and did the freezer thing and the oldwear ring came out with just a little tug. The aftermarket wear ring slipped invery easily; in fact I can pull it out and put it back in with no effort. I wasexpecting to have to, at minimum, tap the new wear ring in. Is it possible thatI got the wrong wear ring or will the 4 retainer screws be enough to hold thenew wear ring? This is on a 2006 Seadoo GTX 4 Tec. Thanks for any help.
12-06-2012, 10:14 AM #2
i find alot of times with the aftermarket rings, they do fit loose. it should be fine. put the screws in, and with the pump bolted to the hull, it will hold the ring in place.
12-10-2012, 09:48 PM #3
- Join Date
- Jul 2012
sounds fine, i had the same problem.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jchait in forum 4-Tec PerformanceReplies: 7Last Post: 06-18-2012, 04:57 AM
By Ocman in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-09-2010, 09:23 AM
By tburn in forum Sea Doo Open DiscussionReplies: 1Last Post: 06-21-2009, 09:14 AM
By engineermike in forum 4-Tec PerformanceReplies: 10Last Post: 09-10-2006, 09:47 PM
By sc6365779 in forum 4-Tec PerformanceReplies: 7Last Post: 08-22-2006, 11:39 AM