Thread: RXP Project
12-06-2012, 01:02 PM #1
In the last few weeks I installed new Supertech valves, Riva Ride plate, heat exchanger, Rotax Oil Pressure valve and Rive ECU. But after starting and dialing in the AFR's the engine starting knocking. After removing the SC and oil filter it was clear that a white metal bearing seized, shavings visible in oul filter and clearly no damage on SC, my only explanation was either big end or small end bearings! Must say was quit disappointed as my summer holiday is only two weeks away.
I have to say have no idea what caused the bearing failure....
Now after some though I would like to do a GPRXP turbo project as I need to remove the engine anyway!
I will certainly need a hull and a lot of assistance on this, will have to import everything, we have limited performance stores in SA!
12-06-2012, 11:12 PM #2
What will a shopping list look like for a turbo GPRXP.....
12-07-2012, 03:16 AM #3
Ivann your best off asking these questions on the conversion side of the forum
there is a list in a sticky there that will help you with your question
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By boostaholic in forum Conversion PWC Performance SkisReplies: 59Last Post: 10-01-2016, 02:24 PM
By Ocman in forum Sea Doo Build ThreadsReplies: 46Last Post: 06-10-2011, 06:30 AM
By Ocman in forum 4-Tec PerformanceReplies: 23Last Post: 05-19-2011, 12:42 AM
By skyman707 in forum Sea Doo Open DiscussionReplies: 10Last Post: 04-27-2010, 10:49 PM
By BoostedRXP in forum 4-Tec PerformanceReplies: 3Last Post: 12-02-2006, 11:05 AM