Results 1 to 3 of 3
  1. #1

    Join Date
    Sep 2012
    Raleigh, NC

    carbon ring installation

    i am working on my 02 seadoo gtx 4 tec
    shaft and everything was removed when i bought it
    working from the back to front
    the bellow is clamped to black plastic around intake area
    my carbon ring is inside the bellows
    is it supposed to be clamped on forward part of bellows??
    then SS retainer, clip , bearing with rubber shield , engine
    is that the order of it?
    tried to get carbon seal out of bellows, its suck in there good

  2. #2

    Join Date
    Jan 2009
    Scotland, UK
    Yes, that`s the right order. You can only replace the carbon ring with the driveshaft removed. Once the shaft is out, you can remove the bellows and carbon ring from the plastic fitting on the hull. You can then remove the carbon ring from the bellows and replace it. Refit it all in reverse order.

  3. #3
    monaroman76's Avatar
    Join Date
    Mar 2008
    Whyalla, South Australia
    You should replace the bellows and the carbon ring as the bellows begins to lose tension over time. It only costs about $20 for a new one from memory.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 0
    Last Post: 08-06-2014, 02:28 PM
  2. carbon ring install problem
    By 3dguy in forum Sea Doo Sport Boats
    Replies: 5
    Last Post: 04-04-2008, 08:58 PM
  3. Carbon Ring Install
    By moultrie rxp in forum 4-Tec Performance
    Replies: 3
    Last Post: 07-31-2006, 03:21 PM
  4. Carbon ring replacement?
    By Rendog in forum Sea Doo Open Discussion
    Replies: 7
    Last Post: 01-02-2006, 07:06 PM
  5. Reinforcement of pump tunnel area around carbon ring
    By Green Hulk in forum 4-Tec Performance
    Replies: 12
    Last Post: 08-03-2005, 03:13 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts