Thread: 4tec Drive Maintenance
12-10-2012, 10:35 AM #1
4tec Drive Maintenance
I have an 04 RXP 215 with 110hrs on it.
The ski does not leak at all, no vibrations, cavitation or bearing noises.
Do you guys think it would be good preventative maintenance to replace the bellow, carbon ring, and any drive line bearings as a precaution?
I was planning on pulling the pump (just to see if I could do it) and replacing the grease in the cone with oil anyway.
What other regular maintenance is required for the drive line?
Once I get the pump out, the drive shaft will slide out as well correct?
Any input is greatly appreciated!
12-10-2012, 11:05 AM #2
If Its not Broken dont Fix it. Visual Inspection Is good always though. Pulling the Pump is Not Bad Checking Around But dont Be a daredevil Risk vs Reward is never Good
12-10-2012, 11:23 AM #3
Although not drive line related, you should have had your SC rebuilt at 100 hrs.
12-10-2012, 11:28 AM #4
yep it has been with 2012 spec rebuild kit. I need to replace the '04 spec valves as well...
12-10-2012, 03:31 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By spannerspencer in forum Sea Doo Open DiscussionReplies: 1Last Post: 08-21-2012, 11:54 PM
WTB - Parts 02 GTX 4Tec drive systemBy Jessie00721 in forum Sea Doo ClassifiedsReplies: 11Last Post: 07-26-2012, 08:12 AM
By taylor757 in forum 4-Tec PerformanceReplies: 10Last Post: 07-16-2012, 06:43 PM
By fireboy in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-02-2010, 10:17 PM
By thompsdw in forum Sea Doo ClassifiedsReplies: 0Last Post: 03-26-2009, 07:28 PM