Results 1 to 3 of 3
  1. #1
    apactorpedo's Avatar
    Join Date
    Aug 2006
    Location
    Lake Mount, FL
    Posts
    191

    boost gauge w/ blow off question

    can i install a boost gauge and keep my blow off valve?


  2. #2

    Join Date
    Feb 2006
    Location
    Birmingham AL
    Posts
    2,924
    +1
    2
    If your refering to the use of the nipple on the manafold you can either just T the vaccume line running from the manafold to the BOV and run it to a boost guage. or drill and trap the IC block off plate (if you are running an external IC) and run you line from there; or there is a second nipple under the ECU you can drill that out and just run a vaccume line off of there. I hope this helps

  3. #3
    apactorpedo's Avatar
    Join Date
    Aug 2006
    Location
    Lake Mount, FL
    Posts
    191
    hey thanks, didnt know if i could or should drill again or use same hole,thanks again

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. RRFPR and boost gauge tap block off
    By bruinsrme in forum 4-Tec Performance
    Replies: 6
    Last Post: 05-05-2008, 12:26 AM
  2. boost gauge question
    By CarFanatic in forum 4-Tec Performance
    Replies: 25
    Last Post: 07-11-2006, 11:05 AM
  3. antone running the dynotune boost gauge ..question 4 u
    By CRAZEDRXP in forum Sea Doo Open Discussion
    Replies: 10
    Last Post: 06-15-2006, 09:05 AM
  4. RIVA SD Supercharger Blow-off Valve Kit an urgent question
    By amirmiz in forum 4-Tec Performance
    Replies: 2
    Last Post: 11-04-2005, 09:25 AM
  5. blow off valve question
    By TroyRXP15 in forum 4-Tec Performance
    Replies: 8
    Last Post: 07-21-2005, 02:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •