Results 1 to 2 of 2

Thread: 01 mpem power

  1. #1

    01 mpem power

    I have an 01 xp and I'd like to find out if there are any open slots in the mpem for a switched power source. I saw the how to page but that is referencing a 4 tec and I'm not sure if the mpem are the same. I'd rather not just tap into my factory bilge pump wiring and just add another to the mpem.

    Thank you


  2. #2
    test terminal 9 and 16 in connector 1 for battery power - these may be the open terminal pins for your "spare" mpem fusesterminal 2 in connector 2 is a ground

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How To: Wire into the MPEM for switched power source.
    By rapidacceleration in forum Sea Doo How To & FAQs
    Replies: 30
    Last Post: 08-24-2012, 06:29 PM
  2. 01' XL800 Power Valve Problems
    By JH1200A1 in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 08-02-2012, 10:07 AM
  3. 01 gp1200r power issues! No display, no crank
    By tulittletulate in forum Yamaha How To & FAQs
    Replies: 4
    Last Post: 05-16-2011, 09:49 AM
  4. wtb 99-01 mpem
    By fast1197r in forum 2-Stroke Performance
    Replies: 2
    Last Post: 04-06-2010, 12:38 PM
  5. MPEM killing power to coil
    By sbell914 in forum 2-Stroke Performance
    Replies: 0
    Last Post: 08-02-2007, 04:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts