Thread: Driveshaft Tool
01-31-2013, 08:50 PM #1
What size holding tool do I need for the splines on the driveshaft of my 2009 SHO ? Is it 20mm or 25mm ?
01-31-2013, 08:52 PM #2
02-01-2013, 02:06 PM #3
So is this tool not the right one ? It says it's for the SHO,FZR,FZS,HO with a 1812cc engine. But it says it's a 20mm tool, I thought for the 1812cc engines you needed a 25mm tool.
02-01-2013, 03:51 PM #4
that's the right one it says fzr fzd sho engine i know for sure the shaft is 25mm so i guess they measured the tool different
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tchies in forum Sea Doo Open DiscussionReplies: 1Last Post: 01-03-2010, 05:58 PM
By t_hoang02 in forum Sea Doo ClassifiedsReplies: 4Last Post: 12-24-2009, 11:38 AM
By jpeconsult in forum 4-Tec PerformanceReplies: 2Last Post: 07-14-2008, 05:49 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 16Last Post: 10-18-2007, 08:32 AM
By rapidacceleration in forum 4-Tec PerformanceReplies: 3Last Post: 04-25-2007, 09:55 PM