02-01-2013, 10:56 PM #1
Starter Solenoid Installation Question
Ok so today I decided to replace my starter solenoid since it has the infamous intermittent operation and will make a click sound and no power to the starter until you press the start button a dozen times or so. The install went fine but I noticed there was a clear gel like substance on the connection posts and the small plug on the side. Is this a type of grease? Is it necessary to re-apply this substance or is everything going to be ok without it? I do not ride in saltwater if that makes a difference.
02-01-2013, 11:26 PM #2
It's dielectric grease, I always use it on all my electrical connections, saltwater or not, it will help protect any electrical connection in a high moisture environment
02-02-2013, 09:24 AM #3
Gotcha thanks. I'll put some on the posts and plug.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jigeye in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 03-10-2011, 10:30 PM
By DKFox in forum 2-Stroke PerformanceReplies: 7Last Post: 07-22-2009, 08:37 AM
By Vern in forum 4-Tec PerformanceReplies: 11Last Post: 07-09-2005, 09:59 AM
By Mark S in forum 4-Tec PerformanceReplies: 2Last Post: 07-01-2005, 09:25 PM
By 05Limited in forum 4-Tec PerformanceReplies: 5Last Post: 06-03-2005, 09:54 AM