Thread: 60lb injectors??
02-05-2013, 05:38 PM #1
Any thoughs about using this injectors at 9000 rpms and 20lb boost... I'm just curious if this injectors will hold on my setup? Maybe 80lb will be best?
02-05-2013, 05:43 PM #2
60's will be over 100% duty cycle at 9000 RPM and 20 psi boost pressure.
Which ECU are you running? If you are using Motec or Athena ECU go with the 1000cc injectors.
If V-Tech reflash go with their 1100cc injectors. They have very good mapping for those injectors.
02-05-2013, 06:09 PM #3
02-05-2013, 06:16 PM #4
Assuming you do not want to go over 85% DC and your fuel pressure can hold 60 PSI over the intake pressure, I am getting 3 - 1150 cc injectors.
02-05-2013, 10:01 PM #5
02-05-2013, 11:17 PM #6
02-05-2013, 11:33 PM #7
Good point Egor thanks for bringing this to my attention. You are right the current injectors from V-tech are for the newer iControl skis with Bosch ECU's.
V-tech is working on their injectors for the skis with Siemens ECU's. As soon as they are released I will make an announcement here on the forum.
02-06-2013, 06:34 AM #8
02-06-2013, 08:48 AM #9
EV-1 (siemens), and EV-6 (bosch) connectors
Could be run with the right harness adapters...
02-06-2013, 09:09 AM #10
So is there any plug and play injectors out there?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By vspec1 in forum Sea Doo ClassifiedsReplies: 4Last Post: 05-02-2010, 09:12 AM
By jp1300r in forum Sea Doo ClassifiedsReplies: 5Last Post: 09-03-2009, 12:25 PM
By palmbeach jesse in forum Sea Doo ClassifiedsReplies: 1Last Post: 07-29-2009, 11:24 PM
By inteljd in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-29-2009, 08:13 AM
By RXPRacer513 in forum Sea Doo ClassifiedsReplies: 3Last Post: 06-18-2009, 08:56 PM