02-07-2013, 05:47 PM #1
I am new to green hulk!!!!!! I get to the point i caught mod bug on my 2011 vxr did manifold up grade kit and air filter now putting on billet drive shaft sleeve kit i think i figure how to take it off but don't know torque specs on jet pump bolts and the others as well. Also what grate to get ss riva or rd 2aquavien thanks for your input.....
02-07-2013, 06:14 PM #2
Welcome to the forum. General guidelines for the bolts are as follows:
M6= 6lb torque
M8= 13lb torque
M10= 23lb torque
I do not have a service manual for your actual model but this should get all sizes you will encounter when pulling the grate, ride plate or pump. Hope this helps I know it may not be the exact torque specs but if you are needing the info fast this is very close. I think that my manual for the 2008 sho shows the m10 to actually be 22.6lb so 23 is still so close it should not matter.
Maybe someone else with your actual service manual can get you exact if you are not comfortable using these numbers.
02-07-2013, 06:42 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Therock in forum 4-Tec PerformanceReplies: 11Last Post: 08-13-2005, 09:04 PM
By SpeedStang95 in forum 4-Tec PerformanceReplies: 1Last Post: 07-30-2005, 04:51 PM
By rx4pain in forum Sea Doo Open DiscussionReplies: 9Last Post: 07-14-2005, 03:15 PM
By Thomas in forum 4-Tec PerformanceReplies: 2Last Post: 07-07-2005, 04:43 PM
By Green Hulk in forum Sea Doo Open DiscussionReplies: 2Last Post: 05-25-2005, 04:38 PM