02-18-2013, 06:14 AM #1
how to change antifreeze sea doo RXT 260 RS ?
Hi guys, I tell you the last day I left to navigate the back I realized that the coolant can lid was open.
My level was below the MIN so I wanted to change all this other antifreeze http://www.pidenosaceite.com/product...g-life-30.html
You see this antifreeze MOTUL correct?
Someone could please post pictures of how I have to empty and refill the coolant circuit?
thank you very much
02-18-2013, 07:04 AM #2
There is a small Allen head bolt in the rear center of the ride plate. Take that out and drain all the coolant. Tilt the ski back on the trailer once it starts trickling out to get the last bit out. Refill through the reservoir located in the engine compartment. Don't forget to put that bolt back in the rideplate before doing so
02-18-2013, 07:26 AM #3
I could put a picture of the screw in question please?
No problem of air into the circuit?
few gallons of antifreeze leads the cooling?
Thank you very much ecpChris
02-18-2013, 07:47 AM #4
02-18-2013, 08:07 AM #5
thank you very much!
with a 5-liter bottle to reach me cricuit ?
how about this antifreeze?
"Long-Life Inugel Motul 30% (Red)
Extended life coolant fluid, antifreeze ready for use, specially formulated for closed cooling circuits in all liquid-cooled engines with components recommended for those services aluminio.Especialmente severe or very severe and / or long-term.
Likewise, it is recommended to open cooling circuits.
Benefits of Motul Inugel 30% Long-Life (Red)
Eespecificaciones: UNE 26-361, SAE J814 / 1034, BS 6580, USA O-A548 and JIS2234
Organic type antioxidants: this new configuration of the formula provides more stability to the formula, guaranteeing long-lasting protection to all items.
High concentration: The concentration of its components such as MEG ensures a high level of protection, both against freeze-up to -40 ° C, as compared to boiling - +136 º C. It also manages to reduce significantly the appearance of the effect "Pitting" (Cavitation wear).
Not involved in its formulation, phosphates, amines, nitrites, nitrates, borates, silicates or benzonatos. Contains bittering components to avoid accidental ingestions. No aggressive.
Dilution: 30% Protection: -18 º C. Color: Red
Instructions for using Motul Inugel 30% Long-Life (Red)
Should not be mixed with other liquids in order to maintain good protective properties. To ensure protection to metals, if water is added, it is preferable that it be demineralized.
02-18-2013, 09:03 AM #6
02-18-2013, 09:04 AM #7
02-18-2013, 09:05 AM #8
02-18-2013, 09:47 AM #9
The drain plug for your boat is the center bolt on your ride plate.
unscrew drain plug and let all old coolant drain out
Pour 1 Gal of distilled water in the coolant tank and let that drain out too
Buy 2 Gals of green coolant NOT Orange!
(with a buddy) start pouring coolant in the coolant tank reservoir and wait until there are no more farts and air bubbles and coolant is pouring out the drain plug in a steady stream. This effectivly bleeds the system forcing out any air bubbles
Plug drain hole (while still filling coolant reservoir) until the coolant reaches between the min and max lines
Go to boat ramp and back trailer into the water keeping boat attached to trailer.
Run boat until it gets up to operating temperature at which point the thermostat will open and flow coolant.
fill reservoir again
02-18-2013, 10:06 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Antiguan FZR in forum 4-Tec PerformanceReplies: 61Last Post: 08-07-2012, 06:47 PM
By drlib in forum Sea Doo Open DiscussionReplies: 4Last Post: 08-24-2011, 03:46 PM
By Sdefreit in forum Sea Doo Open DiscussionReplies: 16Last Post: 10-21-2010, 04:08 PM
By nlpnrxt1 in forum Sea Doo Open DiscussionReplies: 2Last Post: 11-16-2009, 03:01 PM
By jonstephens in forum 4-Tec PerformanceReplies: 7Last Post: 05-17-2005, 05:14 PM