03-11-2013, 01:37 PM #1
Picture of exhaust manifold cut at AFR tap site
See the attached pictures of a 06 exhaust mani at the afr tap site,
As you can see, not much room for error, around the back side it is just as thin,
I think the trick is drill with the 5/8" and only run the tap down just a little bit for the threads,
When I ran the tap all the way down is when it hit the water jacket,
Last edited by skigolfnut; 03-12-2013 at 09:41 AM.
03-11-2013, 01:55 PM #2
That is rather sobering... I would have done it different if I knew that when I taped mine.
03-11-2013, 02:24 PM #3
03-11-2013, 02:27 PM #4
Thats why people with pre 08 went to 08 and newer exhaust the castings are different thicker. anyone with 08 and newer should not be worried with lack of " room for error".
03-11-2013, 02:48 PM #5
- Join Date
- Jun 2008
- GREECE ATHENS , NAXOS
03-11-2013, 03:05 PM #6
Really useful post and photos.
Anyone care to sacrifice an 08+ manifold so we can see the difference?
03-11-2013, 03:35 PM #7
If you pay for it I will cut it how ever you want it
03-11-2013, 03:40 PM #8
03-11-2013, 04:07 PM #9
Rich? Your the one with the private lifts and snow mobiles
03-11-2013, 04:24 PM #10
Very good post thank you for sharing this!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By shrabber in forum Sea Doo ClassifiedsReplies: 1Last Post: 06-16-2011, 12:52 PM
By krouchchocolate in forum 4-Tec PerformanceReplies: 26Last Post: 03-10-2011, 01:16 PM
By rxpblast in forum Sea Doo ClassifiedsReplies: 7Last Post: 10-19-2010, 11:06 PM
By kenshin89 in forum Sea Doo ClassifiedsReplies: 5Last Post: 03-02-2010, 09:21 PM
By boostaholic in forum 4-Tec PerformanceReplies: 2Last Post: 08-29-2008, 01:35 PM