Thread: exhaust temp sensor
03-14-2013, 07:47 AM #1
exhaust temp sensor
I am starting to get my 1200 pv engine reassemblied and bike ready for the upcoming season. The wire from exhaust temp sensor has been beaten up but not broken or fread.
Do I need to connect this sensor ?? The sensor for cat is not used.
I have a new SBT block, riva stage II kit (minus cylinder heads), converter D plate, oil pump by pass kit, carbs rebuilt with upgrades, Boyesen pro-128 reeds w/stuffers and new cages.
03-14-2013, 09:31 AM #2
needs a cat temp chip or 1k ohm resistor
03-14-2013, 09:33 AM #3
03-15-2013, 10:27 AM #4
I have a cat temp chip on the top sensor. Should I also use one on the lower sensor?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By saxy415 in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 03-18-2009, 08:16 AM
By speedskixp in forum Sea Doo ClassifiedsReplies: 0Last Post: 10-27-2008, 01:16 PM
By boostaholic in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-23-2008, 08:37 PM
By whiteyz in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 07-15-2007, 06:27 PM
By CRS in forum 4-Tec PerformanceReplies: 13Last Post: 09-11-2005, 07:55 PM